Jordon wrote:
> Question One: Is it as simple as disconnecting the battery, cutting the
> wires to the marker lights, turn the ignition on and use a continuity tester
> to see which is hot and which is ground?
yes, well, with a voltmeter anyway. Radio shack can hook you up with a cheap
pocket VOM.
>
>
> Question Two: Any suggestions as to where to mount the switch?
Right above the passing lamp switch in the tin. Sheet metal is too thin for a
conventional
drill, use a 1/2 inch spot weld cutter to 'saw' a clean hole without distorting
it. (eighth inch
pilot hole is needed though)
--
HogDr SENS BS#123
---------------------------------------------------------------
HD Dealer Technician at your service......
My Employer's site: http://www.wishd.com
My site: http://www.execpc.com/~patrickz/patricksite.htm
---------------------------------------------------------------
This archive was generated by hypermail 2b30 : Thu Mar 01 2001 - 17:09:22 CST