Ultra Hog wrote:
>
>
> I've had the bike in for repair twice. Same indication on fault codes.
> Shows cam shaft position sensor problem. Cam shaft sensor adjusted on first
> repair. On second repair, a wiring harness connector was replaced. I'm
> going to put it back in the shop but would like to see if anyone else has
> seen any problem like this on other 97s.
>
> D^2
I don't understand the adjustment part. There is no adjustment for the cam
sensor.
Two bolts in two holes and that's it.
Since this sensor also houses the bank angle sensor, which will give you the
same code,
and the latest recall from HD involved the bank angle sensors causing errant
shutdowns,
I would suggest a new sensor plate. The hall effect sensor could be weak as
well, causing
a loss of signal back to the ECM.
Was the cam sensor code the -only- code in the computer? consistently?
HogDr
--
---------------------------------------------------------------
Remove *nospam* to reply
HD Dealer Technician at your service......
My Employer's site: http://www.wishd.com (need Javascript on)
My site: http://www.execpc.com/~patrickz/patricksite.htm
---------------------------------------------------------------
This archive was generated by hypermail 2b30 : Thu Mar 01 2001 - 17:09:06 CST