Chris Troudt wrote:
> atluck@my-deja.com wrote:
> > HD says to start with the spark plug side, exhaust end,
> > then do the same side intake end.
>
> It doesn't matter which bolt you start on as long
> as you torque them in an X pattern. An X is an X.
>
>
Maybe it doesn't make a big difference, but when I set up the cylinders
in torque plates, I torque them as a front cylinder or rear cylinder with the
HD specified pattern. Then I bore and hone, and keep the cylinder torqued
as a front, marked as such, and install it on the front of the engine.
Every little bit helps, IMO.
HogDr
--
---------------------------------------------------------------
Remove *nospam* to reply
HD Dealer Technician at your service......
My Employer's site: http://www.wishd.com (need Javascript on)
My site: http://www.execpc.com/~patrickz/patricksite.htm
---------------------------------------------------------------
This archive was generated by hypermail 2b30 : Thu Mar 01 2001 - 17:09:03 CST